This Ceramic Knife is great for finishing your SD's seams. The ceramic surface cuts through the hard resin smoothly, but will not cut you!
To use your Ceramic Knife you should gently scrape down the area you want to trim. Use a shaving motion to slowly trim off the part you would like to take off. The blade cuts through the resin very easily so be careful not to cut into the material, or to move it from side to side as you might take out more than you intended!
We recommend the Flat Blade for all general uses.
Type = Tools and Supplies
Category = Cutting Drilling and Scribing Modelling Tools
Date of Release = 2020-01-25
Status = Available