Hexagonal Punch and die set (0.7 0.85 1. 1.25 1.5 2.0) The set contains a die plate, 6 different hexagonal punch tool from 0,7 mm up to 2 mm, and a mini hammer.Expensive, but this tool will last a lifetime and is required for any modeler who likes to detail their kits.
Each of these punches is labeled clearly on one end and is constructed from aluminum rod stock with the punch pins being made from steel as seen in the round Punch and Die Set; however, the three smaller sizes on the Hexagonal Set have a secondary guide pin worked into the design to help protect the smaller punch pins from breakage.
The tool is simple to use; place any variety of styrene flat stock into the tool between the clear acrylic top plate and the black steel slip plate; select the correct punch for the job and with a couple of taps from the tiny hammer out pops a perfect hexagonal disc.
Type = Tools and Supplies
Category = Scratch Building and Photo-Etch Tools
Date of Release = 2014-02-14
Status = Available